We found 34077 price guide item(s) matching your search
There are 34077 lots that match your search criteria. Subscribe now to get instant access to the full price guide service.
Click here to subscribe- List
- Grid
-
34077 item(s)/page
Lot 693
A gentleman's lockable mahogany tool cabinet with key by MARPLES 42" x 19" x 33"h. when closed, 52"h. when the slide is raised, with "The Compactum Tool Cabinet" Pat 3258. The cabinet, with 3 draws to the side and one to the front, with two cupboards, converts to a handsome piece of furniture when closed c/w orig vice (repaired) and the swivel stool which was also advertised in the early Marples catalogues G+(300-500)
Lot 1159
A cabinetmakers, lockable, sturdy oak and pine chest 43" x 23" x 24"h. with a sliding bank of 9 draws and dummy draws with figured mahogany hinged top and mahogany fronts with flush brass pulls, over tool well for moulding planes etc. and integral saw till. The lid interior of figured mahogany divided into 19 sunken panels by beaded oak surrounds, the centre panel protruding, an unusual, nice quality chest probably made as an apprentice piece G+(300-500)
Lot 81
Collection Of Antique Horse Brasses (20) Brass Cartridge Loading Tool, Brass Grease Guns, Buckles, Padlock, Spring Scales Etc. And Glass Float, 4 Pairs Of Binoculars Pair Of Ivory And Brass Racing Binoculars, Pair Huet Seria 7 X Field Binoculars, Pair Brass Opera Glasses, Pair Of Leather Cased Opera Glasses
Lot 689
Grahame (Kenneth). The Wind in the Willows, Methuen & Co., 1931, illustrations by Ernest Shepard, a few light spots, t.e.g., later green morocco by Cottage Bindery, Bath, upper cover with gilt tool of Mr Toad, with dragonfly at each corner, spine lettered and decorated in gilt, slipcase, 8vo. (1)
Lot 1
A Victorian brass mounted steel bowfront fender, third quarter 19th century, the openwork rail with anthemia and scrolling foliate cast decoration, with a tool rest standard at each end, 37cm high, 162cm wide; and a set of Victorian brass mounted steel fire irons, late 19th century, comprising shovel, poker and tongs, the reeded, conical grips with foliate cast finials, 78cm high
Lot 4810
A GROUP OF PISTOL ACCESSORIES, comprising: a front-sight adjusting block and a rear-sight adjusting tool for a luger; an artillery Luger cleaning rod; a Luger stripping tool; five Luger magazines (three alloy bases, one plastic base, one Danish alloy base); one Walther 7.65mm magazine; two Mauser 1914 pistol magazines; pair of wooden Luger grips; pair of Walther plastic grips; and two 9mm snap caps; all contained in a modern leather and canvas fitted pistol case. (Qty)
Lot 5288
AN RCBS 4x4 RELOADING PRESS BENCH MOUNTED WITH A LARGE RANGE OF RE-LOADING EQUIPMENT for both rifle and pistol cartridges, in particular, a large quantity of .22 Hornet cases and bullets and Winchester 30.30 cases and bullets together with 9mm cases and bullets as well as a "Bowman", 12-Bore cartridge re-loading tool, bench mounted also a large collection of hand loading tools and bullet casting components.
Lot 5309
A SCARCE .410 BORE SHOT GUN RE-LOADING TOOL, BENCH MOUNTED AND BRASS FRAMED AND STAMPED LMS UNDER A BIRD LOGO, together with a 12 gauge roll over tool of similar design and with the same logo but with iron frame, as well as an incomplete cartridge closer and re-capper combination tool of the P Webley design of 1888 but missing the clamping lever and part of the capper de-capping screw.
Loading...-
34077 item(s)/page